Document Outline

• FOREWORD
• Section 1. SAFETY PRECAUTIONS
• 1.1 General
• 1.2 Pre-operation
  • Operator Training and Knowledge
  • Workplace Inspection
  • Machine Inspection
• 1.3 Operation
  • General
  • Trip and Fall Hazards
  • Electrocution Hazards
  • Tipping Hazards
  • Crushing and Collision Hazards
• 1.4 Towing, Lifting, and Hauling
• 1.5 Additional Hazards / Safety
• Section 2. preparation and inspection
  • 2.1 General
  • 2.2 Preparation For Use
  • 2.3 Delivery And Periodic Inspection
    • Handrail Assemblies
    • Platform Assembly
    • Sizzor Arms
    • Electrical Cable
    • Pivot Pins
    • Lift Cylinder
    • Frame
    • Drive Hubs
    • Tire and Wheel Assemblies
    • Sliding Wear Pad Blocks
    • Hydraulic Oil Supply
    • Steer Cylinder
    • Steer Linkage
    • Steer Spindle Assemblies
    • Control Boxes (Console and Ground)
    • Battery
    • Engine
    • Hydraulic Pump and Valves
    • Platform Placards
    • Lock-Out Cylinders (If Equipped)
  • 2.4 Daily Walk-around Inspection
    • Overall Cleanliness
    • Placards
    • Operators and Safety Manual
    • Machine Log
    • Daily Lubrication
  • 2.5 Daily Functional Check
  • 2.6 Lock-out Cylinder Check - (If Equipped)
  • 2.7 Dual Fuel System
    • Changing from Gasoline to LP Gas
    • Changing from LP Gas to Gasoline
  • 2.8 Torque Requirements
• Section 3. user responsibilities and machine control
  • 3.1 General
  • 3.2 Personnel Training
    • Operator Training
    • Training Supervision
    • Operator Responsibility
  • 3.3 Operating Characteristics and Limitations
    • General
    • Placards
    • Capacities
    • Stability
  • 3.4 Controls and Indicators
    • Ground Control Station
    • Platform Control Station
• Section 4. machine operation
  • 4.1 Description
  • 4.2 General
  • 4.3 Engine Operation
    • Starting Procedure
  • 4.4 Raising and Lowering - (Lifting)
    • Raising
    • Lowering
  • 4.5 Leveling Jacks (Optional)
  • 4.6 Mechanical Platform Extension (Optional)
  • 4.7 Steering
  • 4.8 Traveling - (Driving)
    • Traveling Forward
    • Traveling in Reverse
  • 4.9 Parking and Stowing
  • 4.10 Platform Loading
  • 4.11 Safety Props
  • 4.12 Machine Tie Down
  • 4.13 Towing
• Section 5. emergency procedures
  • 5.1 General
  • 5.2 Emergency Towing Procedures
  • 5.3 Emergency Controls and Their Locations
  • Emergency Stop Switch
  • Ground Control Station
  • Manual Descent - (Engine/Pump Failure - Platform Controls)
  • Manual Descent - (Engine/Pump Failure - Ground Controls)
  • Manual Descent - (Complete Loss of Power)
    • 5.4 Emergency Operation
  • Use of Ground Controls
  • Operator Unable to Control Machine
  • Platform Caught Overhead
  • Righting of Tipped Machine
  • Post-Incident Inspection
    • 5.5 Incident Notification
• Section 6. INSPECTION AND REPAIR LOG