JLG 120-SXJ ANSI Service Manual - Manual (Page 22)

SECTION 2 - GENERAL
2-2 – JLG Lift – 3121105
2.2 SERVICE AND GUIDELINES
General
The following information is provided to assist you in the
use and application of servicing and maintenance proce-
dures contained in this book.
Safety and Workmanship
Your safety, and that of others, is the first consideration
when engaging in the maintenance of equipment. Always
be conscious of weight. Never attempt to move heavy
parts without the aid of a mechanical device. Do not allow
heavy objects to rest in an unstable position. When raising
a portion of the equipment, ensure that adequate support
is provided.
MAKE SURE THAT PERSONNEL ARE CLEAR OF CHASSIS AT
ALL TIMES WHEN JACKS ARE EXTENDED.
JACKS RETRACT AUTOMATICALLY, LOWERING THE CHASSIS.
THE JACKS ARE TO BE USED FOR EXTENDING AND RETRACT-
ING THE AXLES. THEY ARE NOT TO BE USED AS A MAINTE-
NANCE TOOL.
The jacks (if equipped) provided for extending and retract-
ing the axles are not to be used as a maintenance tool.
When performing maintenance on the machine which
requires lifting, use adequate hydraulic jacks for lifting the
machine, not the axle jacks.
Cleanliness
1. The most important single item in preserving the
long service life of a machine is to keep dirt and for-
eign materials out of the vital components. Precau-
tions have been taken to safeguard against this.
Shields, covers, seals, and filters are provided to
keep air, fuel, and oil supplies clean; however, these
items must be maintained on a scheduled basis in
order to function properly.
2. At any time when air, fuel, or oil lines are discon-
nected, clear adjacent areas as well as the openings
and fittings themselves. As soon as a line or compo-
nent is disconnected, cap or cover all openings to
prevent entry of foreign matter.
3. Clean and inspect all parts during servicing or main-
tenance, and assure that all passages and openings
are unobstructed. Cover all parts to keep them
clean. Be sure all parts are clean before they are
installed. New parts should remain in their contain-
ers until they are ready to be used.
Table 2-1. Inspection and Maintenance
Type Frequency
Primary
Responsibility
Service
Qualification
Reference
Pre-Start Inspec-
tion Prior to use each day; or
At each Operator change.
User or Operator User or Operator Operator and Safety Manual
Pre-Delivery
Inspection
Prior to each sale, lease, or
rental delivery.
Owner, Dealer, or User Qualified JLG
Mechanic
Service and Maintenance
Manual and applicable JLG
inspection form.
Frequent Inspec-
tion
In service for 3 months or 150 hours, which-
ever comes first; or
Out of service for a period of more than 3
months; or
Purchased used.
Owner, Dealer, or User Qualified JLG
Mechanic
Service and Maintenance
Manual and applicable JLG
inspection form.
Annual Machine
Inspection
Annually, no later than 13 months from the
date of the prior inspection.
Owner, Dealer, or User Factory-Certified
Service Technician
Service and Maintenance
Manual and applicable JLG
inspection form.
Preventative
Maintenance
At intervals as specified in the Service and
Maintenance Manual.
Owner, Dealer, or User Qualified JLG
Mechanic
Service and Maintenance
Manual