JLG LiftPOD FS80 (1001070465) - Manual (Page 73)

SECTION 6 - SERVICE AND MAINTENANCE
LIFTPOD by JLG 1001070465
www.liftpod.com 6-3
6.2 MACHINE PREPARATION, INSPECTION AND
MAINTENANCE
General
This section provides the necessary information needed by those
personnel that are responsible to place the machine in operation
readiness and maintain its safe operating condition. For maximum
service life and safe operation, ensure that all necessary inspec-
tion and maintenance has been completed before placing the
machine into service.
Preparation, Inspection, and Maintenance
It is important to establish and conform to a comprehensive
inspection and preventive maintenance program. Table 2-1 out-
lines the periodic machine inspection and maintenance recom-
mended by JLG. Consult your national, regional, or local
regulations for any further requirements. The frequency of inspec-
tion and maintenance must be increased as environment, severity
and frequency of usage requires.
Pre-Start Inspection
It is the user's or operator's primary responsibility to perform a Pre-
Start Inspection of the machine prior to use daily or at each
change of operator. Reference Section 2 in this manual for com-
pletion procedures for the Pre-Start Inspection.
The manual must be read in its entirety and understood prior to
performing the Pre-Start Inspection.
Frequent and Pre-Delivery Inspection
The Frequent Inspection and Pre-Delivery Inspection shall be per-
formed by a competent person or a qualified mechanic.
The Frequent Inspection and Pre-Delivery Inspection procedures
are performed in the same manner, but at different times. The Pre-
Delivery Inspection shall be performed prior to each sale, lease, or
rental delivery. The Frequent Inspection shall be accomplished for
each machine in service for 3 months; out of service for a period of
more than 3 months; or when purchased used. The frequency of
this inspection must be increased as environment, severity and
frequency of usage requires.
Reference the appropriate areas of this manual for servicing and
maintenance procedures.
Annual Machine Inspection
The Annual Machine Inspection must be performed by a compe-
tent person or a qualified mechanic on an annual basis, no later
than thirteen (13) months from the date of the prior Annual
Machine Inspection.
Reference the Service and Maintenance Sections of this Manual
and appropriate JLG inspection form for performance of this
inspection.