JLG 860SJ Parts Manual - Manual (Page 280)

7-12 800S 860SJ 3121842
SECTION 7 ELECTRICAL
Ref GROUND CONTROL BOX WIRING DIAGRAM
4933201 Ref Deutz Engine 6/I
4933292 Ref Caterpillar Engine 2/C
501 2920129 AR Bulb, Light
502 to 506 Not Used
505 2400065 1 Fuse, 30Amp
506 2400066 1 Fuse, Holder
507 to 509 Not Used
510 4460708 2 Receptacle, Female - 15 Position
4460226 13 Socket, Female
511 4922771 1 Harness, Angle Sensor
1060902 9.5ft/2.9m Cable - 18/2
511A 4460226 4 Socket, Female
511B 4460424 1 Receptacle, Female - 2 Position
Ref STANDARD HARNESS COMPONENTS
601 to 602 Not Required
603 See Note 1 Pump Harness (Note: Not Available for Purchase.)
7007497 2 Plug (Pump)
603A 7007498 1 Plug (Valve Harness)
604 2 Switch, Tilt Sensor Options (Includes Tilt Sensor):
Use 4360544 Prior to SN 0300066741(was p/n 4360503)
Use 4360544 SN 0300066741 to SN 0300075873 (was p/n 4360528)
4360544 SN 0300075873 to SN 0300085332
604A 4460911 2 Plug, Male Deutsch - 3 Position
4460918 6 Socket, Female
4460912 2 Lock, Wedge
605 See Note 1 Controller Harness Assembly (Lift and Swing) (Note: Not
Available for Purchase.)
605A 7022819 1 Connector, Male - 9 Position
7022820 8 Socket, Female
606 7022824 1 Controller Harness/Circuit Board Assembly (Drive and Steer)
606A 7022825 1 Connector, Female - 9 Position
7022820 7 Socket, Female
607 See Note 1 Speed Control Harness (Note: Not Available for Purchase.)
607A 4460224 1 Connector, Female - 6 Position
4460226 5 Socket, Female
608 See Note 1 Proximity Switch & Harness (Note: Not Available for
Purchase.)
608A 4460320 1 Plug, Male - 2 Position
4460227 2 Pin, Male
609 4922690 1 ADE System Power-Down Harness
609A 3740049 1 Relay
3990010 2 Diode - 6 Amp (Not Shown)
FIGURE 7-2. HARNESS COMPONENTS INSTALLATION (WITHOUT UGM) (PRIOR TO SN
0300085332) (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.