3 operation, Operation -2, General -2 – JLG 120-SXJ Operator Manual User Manual

Page 12

Advertising
background image

SECTION 1 - SAFETY PRECAUTIONS

1-2

– JLG Lift –

3121809

inspection requirements as specified in the machine’s
Service and Maintenance Manual.

• Ensure the footswitch and all other safety devices are

operating properly. Modification of these devices is a
safety violation.

MODIFICATION OR ALTERATION OF AN AERIAL WORK PLAT-
FORM SHALL BE MADE ONLY WITH PRIOR WRITTEN PERMIS-
SION FROM THE MANUFACTURER

• Do not operate any machine on which the safety or

instruction placards or decals are missing or illegible.

• Check the machine for modifications to original com-

ponents. Ensure that any modifications have been
approved by JLG.

• Avoid accumulation of debris on platform floor. Keep

mud, oil, grease, and other slippery substances from
footwear and platform deck.

1.3

OPERATION

General

• Do not use the machine for any purpose other than

positioning personnel, their tools, and equipment.

• Before operation, the user must be familiar with the

machine capabilities and operating characteristics of
all functions.

• Never operate a malfunctioning machine. If a malfunc-

tions occurs, shut down the machine. Remove the unit
from service and notify the proper authorities.

• Do not remove, modify, or disable the footswitch or any

other safety devices.

• Never slam a control switch or lever through neutral to

an opposite direction. Always return switch to neutral
and stop before moving the switch to the next function.
Operate controls with slow and even pressure.

• Hydraulic cylinders should never be left at end of travel

(fully extended or fully retracted) before shutdown or
for long periods of time. Always “bump” control in
opposite direction slightly when function reaches end
of travel. This applies both to machines in operation or
in the stowed position.

• Do not allow personnel to tamper with or operate the

machine from the ground with personnel in the plat-
form, except in an emergency.

• Do not carry materials directly on platform railing

unless approved by JLG.

• When two or more persons are in the platform, the

operator shall be responsible for all machine opera-
tions.

• Always ensure that power tools are properly stowed

and never left hanging by their cord from the platform
work area.

• When driving, always position boom over rear axle in

line with the direction of travel. Remember, if boom is
over the front axle, the direction of steer and drive will
be opposite from normal operation.

• Do not assist a stuck or disabled machine by pushing,

pulling, or by using boom functions. Assist only by
pulling at the chassis tie-down lugs.

• Do not place boom or platform against any structure to

steady the platform or to support the structure.

• Stow boom and shut off all power before leaving

machine.

Advertising
This manual is related to the following products: