JLG 120-SXJ Operator Manual - Manual (Page 35)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3121809 – JLG Lift – 3-5
13. Battery Charging Indicator.
When illuminated indicates a problem in the battery
or charging circuit, and service is required.
14. Engine Air Filter Indicator
When illuminated indicates that the air filter is too
restrictive and needs to be replaced.
15. Engine Oil Pressure Indicator
When illuminated indicates that engine oil pressure
is below normal and service is required.
16. Transmission Pump Oil Filter Indicator
When illuminated indicates that charge pump filter is
too restrictive and needs to be replaced. This indica-
tor has an integral temperature sensor (70 degrees
F.) so that false signals are not generated when the
hydraulic oil is below normal operating temperature.
17. Engine Coolant Temperature Indicator (Ford)
When illuminated indicates that engine coolant tem-
perature is abnormally high and service is required.
18. Hydraulic Oil Filter Indicator
When illuminated indicates that the return oil filter is
too restrictive and needs to be replaced.
19. Engine Oil Temperature Indicator (Deutz)
When illuminated indicates that the temperature of
the engine oil, which also serves as engine coolant,
is abnormally high and service is required.
20. Low Fuel Level Indicator
When illuminated indicates that the fuel level is 1/8
full or less. When the light first turns on, there are
approximately four usable gallons of fuel remaining.
21. System Distress Indicator
When illuminated indicates an abnormal condition
with the engine or engine computer.
22. Axles Set Indicator
When illuminated indicates that the axles are fully
extended.
23. Glow Plug Indicator (Deutz)
When illuminated indicates that the Glow Plugs are
operating. After turning on ignition, wait until light
goes out before cranking engine.
24. Capacity Indicator
Illuminates to indicate the maximum platform capac-
ity for the current position of the platform.
25. Exceeding Operating Radius Indicator
Illuminates to indicate that the platform has
exceeded the approved operating radius and the
boom must be retracted to bring the platform back
into the proper radius.
26. Broken Fan Belt Indicator
Illuminates to indicate that the engine fan belt has
broken. When illuminated, the engine must be shut
down immediately to prevent damage.
Remote Control Box (120SXJ Only)
NOTE: To operate the remote control box, set the SELECT
SWITCH to GROUND and start the engine.
1. Power/Emergency Stop Switch
Position the Power/Emergency Stop switch to the on
position to activate the controls on the remote con-
trol box.
2. Front Steer /Jack / Axle Switch
This switch allows the operator to steer the front
wheels as desired, extend or retract the jacks, or
extend or retract the axles depending upon the posi-
tion of the Jack/Steer/Axle Select Switch. The Speed
Control switch does not affect the steer function.
3. Drive Switch
Position the Drive switch to forward or reverse as
desired.
4. Speed Control
Rotate the speed control when driving to increase or
decrease drive speed as desired.
5. Rear Steer Switch
This switch allows the operator to steer the rear
wheels as desired. The Speed Control switch does
not affect the steer function.