JLG 120-SXJ Operator Manual - Manual (Page 71)

SECTION 5 - OPTIONAL EQUIPMENT
3121809 – JLG Lift – 5-1
SECTION 5. OPTIONAL EQUIPMENT
5.1 MOTION ALARM
A 12-volt alarm horn, mounted on the turntable, provides
an audible warning when the machine is in the travel
(DRIVE) mode. It will function in FORWARD or REVERSE
and for boom functions to warn jobsite personnel the
machine is traveling.
5.2 ELECTRIC GENERATOR
An electric generator mounted on the machine functions
to supply electrical power to the platform. This device will
provide enough power to run assorted power tools.
5.3 STROBE LIGHT
An amber or red rotating beacon may be installed on the
hood or platform. The light will come on when the ignition
switch is in the on position.
5.4 CYLINDER BELLOWS
A one piece accordion shaped rubber bellows may be
attached to the rod end of the cylinder barrel and to the
cylinder rod as close to the rod attach bushing as possi-
ble. The bellows affords protection to the cylinder rod in
either the extended or retracted position. The bellows are
installed on the lift cylinder, slave cylinder, master cylinder
and steer cylinder.
5.5 BOOM WIPERS
A one piece U-shaped neoprene strip, be attached to the
front of the base boom section, wipes the top and both
sides of the fly section. The bottom side of the fly section
is protected by a straight neoprene strip which also
attaches to the base section.
5.6 110 VOLT/60HZ GENERATOR
A 110 volt generator, mounted beside the engine, is belt
driven from the output shaft of the engine. This application
provides for a 110 volt receptacle at the ground control
and also at the platform. The lead from the ground control
and also at the platform. The lead from the ground control
to the platform is routed along the boom power track thus
eliminating the use of extension cords hanging freely from
the platform.
5.7 220 VOLT RECEPTACLE
A 220 volt receptacle may be mounted on the platform
support to eliminate extension cords hanging from the
platform. The lead from the receptacle is routed along the
boom power track to the engine compartment. In the
engine compartment, a plug is installed on the lead for
attachment to an extension cord or a receptacle from a
220 volt power source. When not in use the plug is stored
in a junction box mounted on the engine compartment
frame.
5.8 SPARK ARRESTOR MUFFLER
The spark arrestor is mounted directly aft of the standard
muffler and serves to contain any sparks the engine might
emit that a standard muffler normally would not. The spark
arrestor is a vital option for machines which are operated
in areas where combustible materials are used. The spark
arrestor is available for gasoline, LP gas, and diesel
engines.
5.9 110 VOLT RECEPTACLE
A 110 volt receptacle may be mounted on the platform
control console to eliminate extension cords hanging from
the platform. The lead from the receptacle is routed along
the boom power track to the battery and ground control
compartment at the front of the machine. A plug is
installed on the end of the lead for attachment to an exten-
sion cord or a receptacle from a 110 volt power source.
When not in use the excess wire and plug are to be
stowed.