JLG 20VP (3120848) Operator Manual - Manual (Page 19)

SECTION 2 - PREPARATION AND INSPECTION
3120848 – JLG Lift – 2-7
Figure 2-5. Lubrication Chart.
2
1
3
4, 5
6
Table 2-1.Lubrication Intervals for Various Components
ITEM COMPONTENT
NO/TYPE
LUBE POINTS
LUBE/METHOD
INTERVAL HOURS
COMMENTS 3
MONTHS
150 Hrs.
6
MONTHS
300 Hrs.
1
YEAR
600 Hrs.
2
YEARS
1200 Hrs.
1 Hydraulic Oil Fill To Line on
Reservoir
5 Qt. Reservoir HO - Check Hyd. Oil
Level
HO - Change Hyd. Oil
✔
Check hydraulic oil every 10 hrs.
Change hydraulic oil every 1200
hrs.
2 Drive Wheel
Bearings
4 - Grease Fittings MPG- Pressure Gun ✔
3 Drive Wheel
Gear Box
2 - Gear Box Gear Oil
Change only when serviced -
requires 176cc’s to fill.
4 Caster Axles 2 - Grease Fitting MPG - Pressure Gun ✔
5 Swivel Raceways 2 - Front Casters MPG - Pressure Gun ✔
6 Mast Chains * 2 - Per Section Chain Lube - Brush or
Spray
✔
* Applies Only to Mast Sections with Chains.
Key to Lubricants: MPG - Multipurpose Grease
HO - Hydraulic Oil - See Table 7-1. in Service Manual.
Notes: 1. Be certain to lubricate like items on each side of the machine.
2. Recommended lubricating intervals are based on normal use. If machine is subjected to severe operating conditions,
such as a high number of cycles, location, corrosive/dirty environment, etc., user must adjust lubricating requirements accordingly.
3. Prior to checking hydraulic oil level, operate machine through one complete cycle of lift function (full up and down). Failure to do so will
result in incorrect oil level reading on the hydraulic reservoir.