JLG 680S Parts Manual - Manual (Page 236)

7-24 680S 3121235
SECTION 7 ELECTRICAL
217D 4460473 1 Clamp. Cable
217E 4460466 8 Seal, Plug
217F 4460464 11 Pin, Male 18 Gauge
217G 4460508 4 Pin, Male 12 Gauge
218 4922569 1 Harness Assembly - Tower Boom (12/4 - 18/8) 1/A
1060896 20ft/6.1m Cable, Electrical - 12/4&18/8
218A 4460465 22 Socket, Female 18 Gauge
218B 4460865 2 Connector - 19 Position
218C 4460509 8 Socket, Female 12 Gauge
218D 4460473 2 Clamp. Cable
218E 4460466 8 Seal, Plug
219 to 228 Not Used
229 4922660 1 Holding Valve/Lift Dump Harness Assembly (Note: This is
actually to separate harnesses under the same p/n) E
229A 4460880 2 Connector, DIN
229B 4460320 1 Plug, Male - 2 Position
4460226 2 Socket, Female
229C 4460424 1 Connector, Female - 2 Position
4460267 2 Pin, Male
230 Not Used
231 1 Harness, 110V A/C (To Bulkhead) Options:
4922873 All Specs Except Australian & CE Specs
4922875 Australian & CE Specs Only
Use 1001121670 Sky Welder (All Specs) (was p/n 4922790)
232 1 Harness, 110V A/C (To Generator Box) Options:
4922874 All Specs Except Australian & CE Specs
4922876 Australian & CE Specs Only
Use 1001121669 Sky Welder (All Specs) (was p/n 4922809)
233 4922872 AR Harness, Limit Switch Lower
2 All Specs Except Australian & CE Specs
1 Australian & CE Specs Only
2 Sky Welder (All Specs Except Australian & CE Specs)
1 Sky Welder (Australian & CE Specs Only)
AR To Boom Capacity Length Switch
1060902 20ft/6m Cable, Electrical - 18/2
4460465 2 Socket, Female
4460891 1 Plug, Male - 2 Position
AR To Boom Transport Length Limit Switch
1060902 20ft/6m Cable, Electrical - 18/2
4460465 2 Socket, Female
4460891 1 Plug, Male - 2 Position
234 4922871 AR Harness, Limit Switch Upper
2 All Specs Except Australian & CE Specs
1 Australian & CE Specs Only
2 Sky Welder (All Specs Except Australian & CE Specs)
1 Sky Welder (Australian & CE Specs Only)
1 To Boom Capacity Length Switch
1060902 34ft/10.4m Cable, Electrical - 18/2
4460464 2 Pin, Male
4460897 1 Receptacle, Female - 2 Position
FIGURE 7-3. HARNESS COMPONENTS INSTALLATION (WITH UGM) (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.