JLG 26MRT ANSI Service Manual - Manual (Page 10)

SECTION 1 - SPECIFICATIONS
1-4 – JLG Sizzor – 3120791
Figure 1-1. Lubrication Diagram
Table 1-6. Lubrication Chart
INDEX
NO
COMPONENT NUMBER/TYPE LUBE POINTS LUBE METHODS
INTERVAL
HOURS
1 Wheel Bearings 2- Front Wheels MPG - repack 1200
2 Hydraulic Oil Fill Cap/Drain Plug HO - Check HO Level
HO - Change HO
Daily/1200
3 Hydraulic Return Filter N/A N/A 50/300
4 Charge Pump Filter N/A N/A 50/300
5 Crankcase - Vanguard Gasoline/LP
Engine
FillCap/Drain Plug EO - Check EO Level
EO - Change EO
Daily/50/300
6 Crankcase - Yanmar Diesel Engine FillCap/Drain Plug EO - Check EO Level
EO - Change EO
Daily/50/300
7 Rear Axle FillCap/Drain Plug EPGL - Check EPGL Level
EPGL - Change EPGL
150/1200
KEY TO LUBRICANTS:
EO - Engine Oil
EPGL - Extreme Pressure Gear Lubricant
HO - Hydraulic Oil - Mobilfluid 424
MPG - Multi-purpose Grease
TO AVOID PERSONAL INJURY, USE SAFETY PROP FOR ALL
MAINTENANCE REQUIREING PLATFORM TO BE ELEVATED.
NOTE: 1. Be sure to lubricate like items on each side.
2. Recommended lubricating intervals are based
on maching operations under normal conditions.
For machines used in multi-shift operations and/or
exposed to hostile environments or conditions,
lubrication frequencies must be increased accord-
ingly.
3. Operate hydraulic functions through one com-
plete cycle before checking hydraulic oil level in
tank. Oil should be visible in ADD sight window on
hydraulic tank. If oil is not visible, add oil until oil is
visible in both ADD and FULL sight windows on
tank. Do not overfill tank.