JLG 26MRT ANSI Service Manual - Manual (Page 8)

SECTION 1 - SPECIFICATIONS
1-2 – JLG Sizzor – 3120791
Lift
Up - 34-42 seconds
Down - 31-39 seconds
Platform Capacity
Standard - 1,000 lb. (455 kg).
Manual Platform Extension Capacity
250 lb. (115 kg)
Machine Weight
Approximately 5,200 lb. (2359 kg)
Wheelbase
78.0 in. (2.0 m)
Machine Height (Platform Fully Elevated)
26 ft. (7.9 m)
Machine Height (Platform Lowered)
89.0 in. (2.3 m)
Platform Railing Height
39.5 in. (1.0 m)
Machine Length
105.0 in. (2.7 m)
Machine Width
69.0 in. (1.8 m)
Ground Clearance
5.5 in. (14.0 cm)
Maximum Tire Load
2,030 lb. (921 kg) @ 19 psi (1.3 bar)
1.4 TORQUE REQUIREMENTS
All wheel lug nuts should be torqued to 90 ft lb (122 Nm)
every 150 hours.
NOTE: When maintenance becomes necessary or a fas-
tener has loosened, refer to the Torque Chart Figure
7-1 to determine proper torque value.
1.5 LUBRICATION
Hydraulic Oil
NOTE: Hydraulic oils must have anti-wear qualities at least
to API Service Classification GL-3, and sufficient
chemical stability for mobile hydraulic system ser-
vice. JLG Industries recommends Mobilfluid 424
hydraulic oil, which has an SAE viscosity of 10W-30
and a viscosity index of 152.
When temperatures remain consistently below -20°
F (-7° C), an amount of no. 2 diesel fuel, not to
exceed 20% of system capacity, may be added to
the hydraulic oil reservoir. This diesel fuel will “thin”
the hydraulic oil for easier cold weather operation,
and will almost completely dissipate from the hydrau-
lic system over a several month period of time. When
cold weather is past, it may be necessary to drain
and refill the hydraulic system to rid the system of
any remaining diesel fuel.
Aside from JLG recommendations, it is not advisable
to mix oils of different brands or types, as they may
not contain the same required additives or be of
comparable viscosities. If use of hydraulic oil other
than Mobilfluid 424 is desired, contact JLG Indus-
tries for proper recommendations.
Table 1-1. Hydraulic Oil
HYDRAULIC SYSTEM OPERATING
TEMPERATURE RANGE
SAE VISCOSITY GRADE
0 to +23 degrees F
(-18 to -5 degrees C)
10W
0 to +210 degrees F
(-18 to +100 degrees C)
10W-20,10W-30
+50 to +210 degrees F
(+10 to +100 degrees C)
20W-20