JLG 26MRT Operator Manual - Manual (Page 10)

SECTION 1 - SAFETY PRECAUTIONS
1-4 – JLG Sizzor – 3120891
Do not operate this machine until it has been serviced and
maintained according to the maintenance and inspection
requirements as specified in the machine’s Service and
Maintenance Manual.
Ensure all safety devices are operating properly. Modifi-
cation of these devices is a safety violation.
MODIFICATION OR ALTERATION OF AN AERIAL WORK PLAT-
FORM SHALL BE MADE ONLY WITH PRIOR WRITTEN PERMIS-
SION FROM THE MANUFACTURER
Do not operate any machine on which the safety or
instruction placards or decals are missing or illegible.
Check the machine for modifications to original compo-
nents. Ensure that any modifications have been approved
by JLG.
Avoid accumulation of debris on platform deck. Keep
mud, oil, grease, and other slippery substances from foot-
wear and platform deck.
1.3 OPERATION
General
Do not use the machine for any purpose other than posi-
tioning personnel, their tools, and equipment.
Before operation, the user must be familiar with the
machine capabilities and operating characteristics of all
functions.
Never operate a malfunctioning machine. If a malfunc-
tions occurs, shut down the machine. Remove the unit
from service and notify the proper authorities.
Do not remove, modify, or disable any safety devices.
Never slam a control switch or lever through neutral to an
opposite direction. Always return switch to neutral and
stop before moving the switch to the next function. Oper-
ate controls with slow and even pressure.
Hydraulic cylinders should never be left at end of travel
(fully extended or fully retracted) before shutdown or for
long periods of time. Always “bump” control in opposite
direction slightly when function reaches end of travel.
This applies both to machines in operation or in the
stowed position.
Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
Do not carry materials directly on platform railing unless
approved by JLG.
When two or more persons are in the platform, the opera-
tor shall be responsible for all machine operations.
Always ensure that power tools are properly stowed and
never left hanging by their cord from the platform work
area.
Do not assist a stuck or disabled machine by pushing or
pulling except by pulling at the chassis tie-down lugs.
Stow scissor arm assembly and shut off all power before
leaving machine.
Trip and Fall Hazards
JLG Industries, Inc. recommends that all persons in the
platform wear a full body harness with a lanyard attached
to an authorized lanyard anchorage point while operating
this machine. For further information regarding fall protec-
tion requirements on JLG products, contact JLG Indus-
tries, Inc.
Prior to operation, ensure all gates are fastened and
secured in their proper position. Identify the designated
lanyard anchorage point(s) at the platform and securely
attach the lanyard. Attach only one (1) lanyard per lan-
yard anchorage point.
Keep both feet firmly positioned on the platform floor at all
times. Never position ladders, boxes, steps, planks, or
similar items on unit to provide additional reach for any
purpose.
Never use the scissor arm assembly to gain access to or
leave the platform.
Use extreme caution when entering or leaving platform.
Ensure that the scissor arm assembly is fully lowered.
Face the machine when entering or leaving the platform.
Always maintain “three point contact” with the machine,
using two hands and one foot or two feet and one hand at
all times during entry and exit.