1 capacities, System voltage, Hydraulic system – JLG DVSP Series Service Manual User Manual

Page 14: Drive motor gearbox (gear oil), 2 component data, Hydraulic pump/pump motor assembly, Rear wheel drive motors, Batteries/battery charger, 3 performance data, Platform capacities

Advertising
background image

SECTION 1 - MACHINE SPECIFICATIONS

1-2

– JLG Lift –

3121136

1.1

CAPACITIES

System Voltage

All Models – 24 Volt DC

Hydraulic System

All Models – 5 qts. U.S. (4.7 L)

Drive Motor GearBox (gear oil)

All Models – 6 oz. (175cc)

1.2

COMPONENT DATA

Hydraulic Pump/Pump Motor Assembly

Pump Motor - 24 Volt DC motor, Standard Duty

Pump Displacement

DVL/DVSP – .098 cu. in./rev. (1.6cc/rev.)

Pump Output (Max.)

DVL/DVSP - 1.20 gpm @ 2200 psi @ 23.5 volts and 105

amps @ 45 centistrokes (200 SSU)

Reservoir Capacity

DVL/DVSP - 1 Gallon (3.78 L)

Rear Wheel Drive Motors

Drive Motors -

1/2 HP, 24 Volt DC, Variable

Right Angle, Sealed Gear Box, 40:1 ratio

Brake Shaft and Drive Shaft - Integral to Motor

Parking Brake (must be released for pushing)

Batteries/Battery Charger

Batteries (2) – 12 Volt / 100 Amp Hour –

Deep Cycle Marine - RV

Weight – 65.7 lb. (29.8 Kg) - Per Battery

Battery Charger

Microprocessor Controlled/SCR Circuit Monitor

120/240 Volt A.C. Selectable / 50/60 Hz input

24 volt, 20 amp output - with 2 amp finish

Reset Circuit Breaker

Automatic Charge Circuit

Plug Interlock Circuit

Wet/VRLA Battery Switch

NOTE: The batteries on DVL/DVSP machines require

approximately five (5) hours to fully charge when
drained to LOW BATTERY VOLTAGE warning on the
Ground Control Module LCD display.

1.3

PERFORMANCE DATA

Platform Capacities

Standard -

15DVL - 500 lb. (230kg)

20DVL - 350 lb. (160kg)

StockPicker - 15DVSP - 500 lb. (230kg)

20DVSP - 400 lb. (180kg)

Extendible -

15DVL/ 15DVSP - 500 lb. (230kg)

20DVL Series - 350 lb. (160kg)

Molded -

15DVL/15DVSP - 500 lb. (230kg)

20DVL Series - 350 lb. (160kg)

NOTE: Distribute weight evenly in platform when loading.

Reference the capacity decal on the machines’ decal
billboard mounted on mast.

Platform Size

Standard - 26in.-W x 26 in.-L (66cm) x (66cm)

Stockpicker - 28in.-W x 48in.-L (71cm x 122cm)

Extendible - 26in.-W x 49in.-L (66cm x 124cm)

Moulded - 25in.-W x 26in.-L (64cm x 66cm)

Machine Height (platform stowed)

DVL/DVSP - 78 in. (198cm) height

Base Footprint

DVL/DVSP - 29.25in.-W x 52in.-L (74cm) x (132cm)

1.4

TORQUE REQUIREMENTS

When maintenance becomes necessary or a fastener has
loosened, refer to the applicable Torque Chart in this section
of the manual, to determine proper torque values.

Advertising
This manual is related to the following products: