JLG DVSP Series Service Manual - Manual (Page 55)

SECTION 3 - BASE COMPONENTS
3121136 – JLG Lift – 3-25
General Component Installation Notes
When removing components make note of the wiring con-
nections before disconnecting the wiring between the com-
ponents within the charger assembly. Only disconnect
enough wiring to remove a component.
The battery charger manual supplied with the machine con-
tains a wiring diagram for the charger as well as Figure 3-10.
at the end of this section of the manual.
Battery Charger Installation
1. Disconnect the positive (+) battery cable from the
left side battery.
2. Carefully raise the lift to gain access to the under-
side of the base frame. Refer to "Positioning Lift For
Access to Components Located Under the Base
Frame" in Section 2.
3. Disconnect the wiring connectors from the back of
the charger assembly.
4. Remove the four (4) capscrews and washers secur-
ing the charger to the base frame on the front of the
charger.
5. Swing the front tie down lug up and remove the
charger from the machine and place on a suitable
work bench for disassembly.
Cover Installation
AC Line Fuse Installation
Battery Charger - Remove/Install
1. Battery Charger Assembly
2. Charger Capscrews/Washers (4)
3. Front Tie Down Lug (Swing Up)
1 2
3
Battery Charger Cover - Remove/Install
1. Charger Cover 3. Screws - Same on Both Sides
2. Bottom Tray Screws (Removal Optional)
AC Line Fuse - Remove/Install
1. AC Line Fuse 3. Back of Charger
2. Cap Screw/Lock Washer/Nut
2
3
1
1
2
3