JLG DVSP Series Service Manual - Manual (Page 78)

SECTION 4 - CONTROL COMPONENTS
4-20 – JLG Lift – 3121136
Joystick Assembly Installation Joystick Calibration Procedure
1. Turn off all power to the platform control module.
2. Plug jumper tool JLG Part Number 7024361 into the
programming socket under the front of the platform
control console. This will short pins two (2) and three
(3) in the socket.
3. Turn the machine power on while holding down the
turtle button on the platform control module button
pad.
4. The platform control LED’s will indicate calibration
mode selected - 10 (ALL) LED’s flashing.
5. Release the turtle button.
6. Run the joystick shaft around the gate of the of the
joystick two (2) to three (3) times. Release the joy-
stick to center.
7. Disconnect the jumper tool from the socket under
the front of the platform control module.
8. Turn off system power.
The joystick calibration is now complete.
Joystick Installation
1. Knob Set Screw (a) 3. Joystick Attach Screws
2. Emergency Stop Switch (Release/Lock Lever)
Notes: (a) Apply Loctite #222 to threads on final assembly.
Joystick replacement requires Joystick Calibration
when complete.
2
1
3
Programming Socket
(On Front of Platform Control Module)
1. Pin-1 2. Pin-2 3. Pin-3
Run Joystick Shaft Around Joystick Gate 2 to 3 Times
Before Returning It To Center
1 2
3
POINT G