JLG 450AJ ANSI Service Manual User Manual
Page 61
Advertising
SECTION 2 - PROCEDURES
3120749
– JLG Lift –
2-43
8.
Using retaining ring pliers, insert retaining ring (7B)
into the groove on input shaft (7A) by compressing
the spring and spacers together.
9.
With large splined end down, place input shaft sub-
assembly (7) into spindle (1A).
10.
Place thrust spacer (9) onto input shaft (7).
11.
Set carrier sub-assembly (3) on a flat work surface
so the large ends of cluster gears (3F) face up.
Locate the punch marks on the face of each cluster
gear (3F) and position them at 12 o’clock.
Figure 2-30. Cluster Gear Punch Marks
Advertising
This manual is related to the following products: