JLG 41EL Operator Manual - Manual (Page 41)

SECTION 4 - MACHINE OPERATION
3120781 – JLG Lift – 4-9
Transport Vehicle Tie Down
(See Figures 4-5, 4-6 & 4-7.)
When placing the EL machine onto a transport vehicle for
transport to another worksite, always tie machine securely
to the transport vehicle using the tie down lugs provided
on the machine. There are three tie down lugs, one on the
rear of the machine, and one on each side. There are also
two cross strap saddles at the center on each side of the
base frame. Use the tie down lugs and cross strap sad-
dles as needed. Tie down methods shown are for illustra-
tive purposes only.
Lifting
If it becomes necessary to lift the machine, use suitable
lifting equipment capable of handling the weight of the
machine, see below.
NOTE: Fork lifts, cranes, chains, slings, etc. must be capa-
ble of handling the following weights:
NOTE: All EL models are equipped with forklift pockets at
the mast end of frame for transporting the unit. An
optional lifting hook which attaches to the top rear of
the mast is available. Do not attempt to lift from over-
head without the optional lifting hook.
Figure 4-5. EL Tie Down Procedure - (When loaded
into a Pick-up Truck bed using the optional load
device).
FRONT OF TRUCK BED
TAILGATE
VIEW FROM OVERHEAD
TIED TO
SIDE LUG
TIED TO
SIDE LUG
Table 4-2. EL Machine Gross Weights
EL Model Gross Weight
20EL-AC 715 lb. (325kg)
20EL-DC 785 lb. (356kg)
25EL-AC 800 lb. (363kg)
25EL-DC 870 lb. (395kg)
30EL-AC 870 lb. (395kg)
30EL-DC 940 lb. (427kg)
36EL-AC 972 lb. (441kg)
36EL-DC 1042 lb. (473kg)
41EL-AC 1070 lb. (486kg)
41EL-DC 1140 lb. (518kg)