JLG 41AM (3120752) Service Manual - Manual (Page 15)

SECTION 1 - SPECIFICATIONS
3120752 – JLG Lift – 1-3
1.6 HYDRAULIC PRESSURE ADJUSTMENT
(See Figure 1-1.)
Adjust system pressure so that platform will raise with
rated capacity in platform.
Turning adjustment screw clockwise, increases system
pressure, turning screw counterclockwise, decreases
system pressure.
Do not adjust system pressure higher than required to
raise the load. Make pressure adjustment with oil at nor-
mal operating temperature. If pressure is set when oil is
cold, platform may not raise rated load after oil has
warmed.
1.7 CYLINDER SPECIFICATIONS
NOTE: All dimensions are given in inches (in), with the met-
ric equivalent, centimeters (cm), given in parenthe-
ses.
1.8 SERIAL NUMBER LOCATIONS
For machine identification, a serial number plate is affixed
to the machine. The plate is located on the back of the
mast, just above the mast support bracket.
Figure 1-1. Hydraulic Pressure Setting - Adjustment
Screw Located at Base of Pump Motor
(Remove Hex Head Cap as Shown)
PRESSURE
ADJUSTMENT
SCREW
HYDRAULIC
OILTANK
GROUND
CONTROL
STATION
COVER
ADJUSTMENT
SCREWCAP
(SHOWNREMOVED)
Table 1-3. Cylinder Specifications
DESCRIPTION
BORE
in./(cm)
STROKE
in./(cm)
ROD DIA.
in./(cm)
Lift Cylinder -
20AM-AC & DC 1.63
(4.14)
56.50
(143.50)
1.38
(3.50)
Lift Cylinder -
25AM-AC & DC 1.63
(4.14)
56.50
(143.50)
1.38
(3.50)
Lift Cylinder -
30AM-AC & DC 1.63
(4.14)
56.50
(143.50)
1.38
(3.50)
Lift Cylinder -
36AM-AC & DC 1.63
(4.14)
83.25
(211.40)
1.38
(3.50)
Lift Cylinder -
41AM-AC & DC 1.63
(4.14)
78.25
(198.75)
1.38
(3.50)