JLG 680S Operator Manual - Manual (Page 55)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121233 – JLG Lift – 3-19
8. Fuel Level Indicator
Indicates the level of fuel in the fuel tank.
9. Creep Speed Indicator
When the Function Speed Control is turned to the creep
position, the indicator acts as a reminder that all func-
tions are set to the slowest speed.
10. Malfunction Indicator
The light indicates that the JLG Control System has
detected a malfunction and a Diagnostic Trouble Code
has been set in the system memory. Refer to the Service
Manual for instructions concerning the trouble codes
and trouble code retrieval.
The malfunction indicator light will illuminate for 2-3 sec-
onds when the key is positioned to the on position to act
as a self test.
11. Cable Service Indicator (If Equipped)
When illuminated, the light indicates the boom cables
are loose or broken and must be repaired or adjusted
immediately.
IF THE CABLE SERVICE INDICATOR IS ILLUMINATED, RETURN THE
PLATFORM TO THE STOWED POSITION, SHUT DOWN THE MACHINE,
AND HAVE THE BOOM CABLES INSPECTED.
12. Soft Touch Indicator (If Equipped)
Indicates the Soft Touch bumper is against an object. All
controls are cut out until the override button is pushed,
at which time controls are active in the Creep mode.
13. Drive Orientation Indicator
When the boom is swung beyond the rear drive tires or
further in either direction, the Drive Orientation indicator
will illuminate when the drive function is selected. This is
a signal for the operator to activate the Drive Orientation
Override Switch and verify the drive control direction is
correct.