JLG 400CRT Operator Manual - Manual (Page 25)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3121803 – JLG Lift – 3-5
9. Start Switch - A momentary contact, push button
type switch that supplies electrical power to the
starter solenoid when the emergency stop switch is
in the on position and the start button is depressed.
10. Glow Plug Switch - (Diesel Engine Only) - This,
momentary contact, toggle switch supplies electrical
power to the engine’s glow plugs to assist cold start
operation.
11. LP/Gas Select Switch - A two position switch is pro-
vided at the platform control panel to allow the oper-
ator to choose between LP/Gas.
12. Fuel Gauge - All the lights will be illuminated when
the fuel supply is full. The lights will go out as the
fuel supply depletes.
13. Tilt Alarm Warning Light - A red warning light on the
control panel that illuminates when the chassis is on
a severe slope.
IF TILT ALARM IS ON WHEN PLATFORM IS RAISED, LOWER
PLATFORM COMPLETELY, THEN REPOSITION MACHINE SO
THAT IT IS LEVEL BEFORE RAISING PLATFORM.
14. Tilt Alarm Warning Horn - The Tilt Alarm Warning
Horn is activated when the chassis is on a severe
slope and platform is elevated.
DO NOT OPERATE MACHINE IF HIGH DRIVE SPEED OPERATES
WHEN PLATFORM IS RAISED ABOVE THE STOWED POSITION.