Appendix – IOGear GUW2015VKIT User Manual
Page 39
38
39
I. Compatibility with IOGEAR GUWH104KIT
Important: To retain the functionality of both the Wireless VGA kit and the GUWH104KIT, you MUST follow
these steps:
Uninstall the GUWH104KIT software by using Add/Remove Programs or Programs and Features on
1.
the Control Panel. Please select and remove “Ultrasuite with WiCenter Basic”. The Wireless VGA kit
installer will not allow you to proceed until this software is removed.
Complete the installation of the Wireless VGA kit as shown in the Wireless VGA Software Installation
2.
section.
Install the GUWH104 software “Driver Hub Only” for your Wireless USB Hub from IOGEAR
3.
website. Please make sure that you are in the correct product page.
http://www.iogear.com/support/dm/driver/GUWH104#display
Use the Wireless USB Host Adapter (GUWA200) that comes with this kit to communicate with your
4.
Wireless USB Hub.
Note: After this upgrade, the Wireless USB Host Adapter (GUWA100U) will not function with the
Wireless VGA Adapter (GUW2015V) or the Wireless USB Hub (GUWH104) on the PC system
where the GUW2015VKIT software has been installed. However you may use this Wireless USB
Host Adapter (GUWA100U) on a different PC.
For more support information, please contact IOGEAR.
Appendix