B&K AVR202 Plus - Manual (Page 38)

13259 0303 35
Setup variable ‘EQ 1’ - allows you to set default bass and treble settings for use with all input sources. Many
systems allow only adjustment of bass and treble levels at fixed frequency points. Your receiver allows you to
adjust level and frequency to aid in adjusting your room for a flat frequency response. Set bass and treble to the
values you would like have restored into the variable ‘EQ 1’ whenever your unit comes out of sleep or whenever
manually selecting a source (see Select variable ‘EQ 1’ under OPERATION Equalization).
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) . (UP) or - (DOWN) move to Bass Frequency
2 ¶ (REW) or • (FF) VOLUME KNOB set to desired bass frequency
3 À(PAUSE) or §(STOP) . (UP) or - (DOWN) move to Bass Level
4 ¶ (REW) or • (FF) VOLUME KNOB set to desired bass level
5 À(PAUSE) or §(STOP) . (UP) or - (DOWN) move to Treble Frequency
6 ¶ (REW) or • (FF) VOLUME KNOB set to desired treble frequency
7 À(PAUSE) or §(STOP) . (UP) or - (DOWN) move to Treble Level
8 ¶
(REW) or
•
(FF) VOLUME KNOB set to desired treble level
9 MENU
∠ MENU
return to SETUP SYSTEM
SETUP ROOM EQUALIZATION
Test Tone 100.0 Hz Off
Notch 100.0 Hz 0.0 dB
Notch Width 97.6 - 102.4 Hz
Bass 100.0 Hz 0.0 dB
Treble 10.0 kHz 0.0 dB
next item adjust
MENU setup system
bass 100.0 HZ
100.0 Hz