B&K AVR202 Plus - Manual (Page 42)

13259 0303 39
Inputs
Usually these settings may be left set to the factory defaults. However, your receiver allows ‘fine tuning’ how your
receiver operates after the selection of an input source. Make sure you are in the SETUP MENUS and your
remote is in B&K mode.
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) . (UP) or - (DOWN) move to Inputs
2 SEL or ENTER ↵ (ENTER) activate SETUP INPUTS
Select input -
From Remote From Front Panel Action
1 ¶ (REW) or • (FF) VOLUME KNOB select source
Set the favorite audio listening mode - Your processor provides for 4 audio listening modes Mono, Stereo,
Surround and DVD Audio (Optional) (See AUDIO MODES). You may set a default audio mode and speaker
selection (excluding selection 0 ‘Headphone’, or selection 9 ‘LtRt’) for each of your input sources. When a source
is selected from the remote control or front panel, the audio mode will automatically be set to use this favorite
mode and speaker selection. Note that DVDA mode can only be selected if that input is designated as the DVD
audio input below and the internal DVDA switch has been set (see DVD Audio using the Coax digital inputs under
MAKING THE CONNECTION).
MAIN MENU
1 Zone 1 Operation
2 Zone 2 Operation
3 Zone 1 Favorite Presets
4 Zone 2 Favorite Presets
5 System Setup
6 Memory Backup/Restore
next item SEL select
MENU exit menu system
5 System Setup
SETUP SYSTEM
1 Speakers
2 Displays
3 Inputs
4 Presets
5 Equalization
next item SEL select
MENU main menu
3 Inputs
SETUP INPUTS SYSTEM SETUP
SETUP DVD INPUT
1 Favorite Mode Surround
2 Favorite Speakers 7
3 Level 0.0 dB
4 Name DVD
5 Component Video 2
6 DVD Audio Input No
next item adjust
MENU setup system
SETUP DVD
SETUP DVD INPUT