Echo CH8670H Owners Manual v.4 - Manual (Page 15)

11 8 INCH TURNTABLE CHIPPER
ENGLIS
h
section
opERaTIoN
As with any other piece of outdoor power equipment, get-
ting the feel for how your machine operates and getting to
know the best techniques for particular jobs are important
to overall good performance.
chIppING opERaTIoN
The chipping operation takes place on the front of the ma-
chine, where hardened steel chipper blades are mounted
on a rotating disk assembly. Material fed into the chipper
chute is sliced into small chips and propelled out through
a discharge tube.
Before starting, fill engine with oil to the correct level 1.
(see engine manual for operation and maintenance
instructions).
Fill fuel tank with unleaded regular gasoline. DO NOT
2.
MIX OIl WITH gASOlINE.
Check hydraulic fluid level and fill to correct level if
3.
necessary.
Make sure the feed roller control bar is in the Stop
4.
position. The controller will flash red until the bar is
in Stop. See Sec. 7.3 for a table of all flash codes for
the controller light.
Move engagement handle upward to disengage drive
5.
belts
Start the engine (see engine owners manual).
6.
Once engine is running and no choke is needed, 7.
set engine to 1/4 throttle and slowly release the
engagement handle. this will engage the drive belt
and the disk will turn.
If the engine stalls when engaging the drive belt, either
8.
use more choke or increase engine rPM.
Bring engine to full RPM.
9.
Move throttle to SlOW position. 1.
Move engagement handle upward to disengage drive 2.
belt.
Shut off engine (see engine owner's manual).
3.
allow machine to come to a complete stop. 4.
4.1 STaRTING ThE machINE
4.2 SToppING ThE machINE
The disk will continue to turn for some time after the
engine has been shut off. Make sure disk has stopped
completely before inspecting or servicing machine.
NoTE
4
WaRNING
Move machine to a clear, level area outdoors before
starting. Do not operate in the vicinity of bystanders.
Make sure cutting chamber is empty before starting.
WaRNING
Before operating your machine, be sure you read
and understand all safety, controls and operating
instructions in this owner’s manual and on your
machine. Failure to follow these instructions can result
in serious injury or property damage.
If forward and reverse feed positions are reversed when
you power up the machine, you may have plugged the
connectors into the wrong plug.
NoTE
4.3 RoTaTE chIppER baSE
disengage turntable brake. 1.
rotate the turntable to desired position. 2.
Once the turntable has been properly positioned, 3.
engage brake.
The chipper base must always be locked in place.
Failure to do so may result in machine vibration, seri-
ous bodily injury or death.
WaRNING