Echo 77412 Owners Manual v.4 - Manual (Page 14)

4.5 INCH CHIPPER 12
ASSEMBLY
2.2.1 lighTS
If assembling 390CC models to the optional configura-
tion shown in Figure 7, move the trailer lights by following
these steps:
1. Remove the bolts connecting the RH and LH light
brackets to the trailer.
2. Disconnect the trailer light wiring harness from the
lights by pushing a punch into the wire release hole
(Figure 4).
3. Cross the taillights and attach them to the other end of
the trailer. make sure the right tail light is attached to
the right side of the trailer, and the left light is on the
left side.
4. Reconnect the wiring harness.
5. Test the blinker and brake lights to ensure the wiring
is properly connected.
2.2.2 aXle and Wheel aSSemblY
Attach the fender weldment to the fender mount with 1.
two 5/16" x 1" bolts and one 5/16" x 3/4" bolt. Attach the
fender mount to the axle with two 1/2" x 1-1/4" bolts.
Slide a wheel onto the hub. Install four 1/2" nuts and
2.
tighten to 75 Ft-lb. Repeat for the other wheel.
position the trailer onto the axle using a hoist or
3.
jack:
Standard configuration (figure 5 & 6): a. Locate
the holes on the sides of the trailer farthest from
the engine. Align these holes with the top holes
on the axle support brackets located on the axle.
Attach with one 3/8" x 1" bolt and one 3/8" x 1-1/4"
bolt on each side.
Figure 4, Disconnecting the wiring harness
Figure 5, standard trailer/hitch assembly
(Models 77413, 77413s)
Figure 6, standard trailer configuration
(Models 77413, 77413s)
Figure 7, optional trailer configuration
(Models 77413, 77413s)
2.2 Trailer assembly (390CC models)
optional configuration (figure 7): b. Locate the
holes on the sides of the trailer closest to the
engine. Align these holes with the top holes on the
axle support brackets located on the axle. Attach
with one 3/8" x 1" bolt and one 3/8" x 1-1/4" bolt
on each side.
noTe
The optional trailer configuration with the discharge tube
is optimal for discharging material into a pickup bed. The
standard configuration is used when discharging material
directly to the ground.