AiM LCU-One CAN for MXL QM/EVO3 QM - Manual (Page 15)

LCU-ONE CAN connected to MXL QM and EVO3 QM
User Manual
Release 1.04
4
Chapter 5 – Configuration on MXL QM – EVO3 QM
To use LCU-ONE CAN with MXL/EVO3 QM you need to configure it using DragOn
software. Please refer to the installation manual for further information about the software.
To configure Lambda Controller run the software and select the logger manager layer as
explained before. To configure LCU-ONE it is necessary to activate “CAN-Expansions
configurator” layer, present in all loggers manager layer
In case of very first configuration the layer appears empty as shown below.
Press “Add Expansion” button and the
window here on the right appears.
Select LCU-ONE CAN (only CAN). The
field under the keyboard enables, press
“Get serial number from a connected
expansion” button and the system
reads the LCU-ONE serial number. It is
also possible to manually insert the
serial number getting it from LCU-ONE.
This operation is to be repeated as
many times as many Lambda probes
are connected.
www.aim-sportline.com
14