AiM MyTach - Manual (Page 6)

MyTach – User Manual
Release 1.04
3 – How to charge the battery
www.aim-sportline.com/mytach 6
MyTach uses a Lithium battery pack.
1 – Snap MyTach into the docking station
2 – Plug the cable to the adapter and in the docking station as
follows:
•
Mini USB connector in the docking station
•
USB connector in the adapter or in the PC (switched on).
3 – When MyTach is charging, the message “Charging” and the
percentage of battery status appears on the display.
4 – Disconnect MyTach once charging is complete (100%)
By default MyTach starts GPS initialization.
When charging is completed the battery indicator has 8 marks and
the duration with GPS switched on is of approximately 9 hours.
After 20 minutes of inactivity or if GPS is disabled (keep “GPS on-off”
pressed for 2”) MyTach switches to power save mode and runs only
as a watch.
The duration of the battery in power save mode is about.100 hours.
To exit power save mode keep “GPS on-off” pressed for 2”
NOTE : To start recording battery charge status must have at least 2 marks.