AiM GSX-R 1000 - Manual (Page 13)

MXL P&P SUZUKI GSX-R K3
User Manual
Release 1.07
www.aim-sportline.com
Once removed the screws, it is possible to
uninstall the stock dash and rotate it
towards himself and unplug it from the high
beam.
Figure 15 : stock dash removal
Once removed the stock dash, unplug the
16 pins AMP connector from the back of
the dash.
Remove the plastic cover, press the tongue
(highlighted by an arrow Figure 16) and
unplug the connector from the dash.
Figure 16 : unplugging the stock dash conector.
Figure 17 shows gear and water
temperature stock connectors default
position.
For further information concerning the
stock connectors refer to Figures from 18
to 19.
Figure 17 : stock connectors position
The gear connector, shown in Figure 18 is
a 3 pins white connector, usually placed on
the left part of the bike (see Figure 17).
Here below are shown the two gear
connectors: male and female.
Note: cable colours correspond to real
ones.
Figure 18 : gear connector – particular
White connector
To the engine To the ECU
13