AirLive AirVideo-100v2 User Manual
Page 36
2. Getting Start
AirLive AirVideo-100v2 User’s Manual
31
< IP Setup>
z
You can select “obtain IP address automatically” or “Use the following IP
address”
z
IP
Address:
The
default value is 192.168.100.10.
z
Subnet Mask: The default value is 255.255.255.0
z
Default
Gateway:
The
default value is 192.168.100.10
z
DNS Server: The default value is 192.168.100.10
<DHCP Server Setup>
z
You can select “Auto(Enable/Disable DHCP Server” or “Disable”)
z
Start IP: The start IP address of DHCP Server.
z
End IP: The end IP address of DHCP Server
z
Subnet Mask: The default value is 255.255.255.0
z
Default
Gateway:
The
default value is 192.168.100.10
z
DNS Server: The default value is 192.168.100.10
< Wireless Setup>
z
Wireless LAN: The default value is “Enable”.
Embedded AP SSID:SSID string ,max. Length is 32 bytes.
z
Connect to Existing AP: This is “AP client” mode feature. By this feature you can
join others Access Point via wireless.
First, enter the existing AP’s SSID and require security key in “Existing AP SSID”
and “Key”, then reboot your system. After these steps, WPS will connect to this AP
by wireless automatically.
※
Note:
The default value of AP client mode is “Disable”, and LAN function will
be disabled during AP client mode.
z
Region: default value is “Worldwide”.
z
SSID Broadcast: The default value is “Enable”
z
Channel: to set fixed channel or Auto. The “Auto” means after power on WPS, it
will scan all of wireless channel and select clear one channel automatically.
z
Encryption: you can select “Disable” or one of WEP/WPA/WPA2 64bit or 128bit in
ASCII or HEX string.
z
Key: If Encryption is enabled, you have to set key value according to the
encryption mode you selected.