AirLive AirVideo-100v2 - Manual (Page 60)

4. Appendix
AirLive AirVideo-100v2 User’s Manual
55
3. Click Device Manager.
4. Double-click on “Network Adapters”.
5. Right-click on Wireless Card bus Adapter or your specific network
adapter.
6. Select Properties to ensure that all drivers are installed properly.
7. Look under Device Status to see if the device is working properly.
8. Click “OK”.
Q: Something wrong with the wireless connection?
A:
— Can’t setup a wireless connection?
I. Ensure that the SSID and the encryption settings are exactly the
same to the Clients.
II. Move the AirVideo-100v2 and the wireless client into the same room,
and then test the wireless connection.
III. Disable all security settings such as WEP, WPA and WPA2-PSK.
IV. Turn off the AirVideo-100v2 and the client, then restart it and then turn
on the client again.
V. Ensure that the LEDs are indicating normally. If not, make sure that
the power and Ethernet cables are firmly connected.
VI. Ensure that the IP Address, subnet mask, gateway and DNS settings
are correctly entered for the network.
VII. If you are using other wireless device, home security systems or
ceiling fans, lights in your home, your wireless connection may
degrade dramatically. Keep your product away from electrical devices
that generate RF noise such as microwaves, monitors, electric
motors…
— What can I do if my wireless client cannot access the
AirVideo-100v2?
I. Out of range: Put the router closer to your client.
II. Wrong SSID or Encryption Key: Check the SSID or Encryption
setting.
III. Connect with wrong AP: Ensure that the client is connected with the