AirLive BU-2015 - Manual (Page 26)

6. Configuration
AirLive BU-2015 User’s Manual 21
- Subnet Mask: Input subnet mask
- Gateway: Input gateway address
- Primary DNS: Input DNS server’s IP address
- Secondary DNS: Input backup DNS server’s IP address, you can leave this field
blank.
* You can leave this field blank, if you only wish to use IPv4 or IPv6 IP address.
Enable UPnP Discovery: Check this box to enable other devices on network to
discover the presence of this IP camera by UPnP. It’s recommended to enable this
function.
Enable UPnP Port Mapping: When UPnP is enabled, check this box to enable UPnP’s
port mapping.
IP Address
(IPv4/IPv6) Enter the IP address of the camera. The default setting is
192.168.1.100 .
Subnet Mask Enter the Subnet Mask of the camera. The default setting is
255.255.255.0 .
Default Gateway Enter the Default Gateway of the camera. The default
setting is
192.168.1.254
Primary/
Secondary DNS DNS (Domain Name System) translates domain names into
IP addresses. Enter the Primary DNS and Secondary DNS
that are provided by ISP.
z
PPPoE:
Select this option to use PPPoE to connect to network. You have to input PPPoE
username and password assigned by network operator to get connected.
z
HTTP Port:
Input IP camera’s web connection port number here. When this port number is
changed, you need to change web browser’s port number you used to connect to IP
camera.
For example, if the IP camera’s IP address is 192.168.2.3 and you changed HTTP port
number to 82, please input ‘http: //192.168.2.3:82’ in web browser’s address bar to
access IP camera’s web configuration interface.
z
RTSP Port:
Input RTSP port number. When this port number changes, you must change
corresponding settings in external network devices (NVR or CMS software) so they
can receive this IP camera’s video.