AirLive N450R User Manual
Page 47
AirLive N450R User’s Manual
42
(E) WPA
Check Box was used to switch the function of the WPA. When the WPA function is
enabled, the Wireless user must authenticate to this router first to use the Network
service. RADIUS Server IP address or the 802.1X server’s domain-name. Select
Encryption and RADIUS Shared Key.
n If you select HEX, you have to fill in 64 hexadecimal (0, 1, 2…8, 9, A, B…F) digits.
n If you select ASCII, the length of pre-share key is from 8 to 63.Key value shared
by the RADIUS server and this router. This key value is consistent with the key
value in the RADIUS server.
(F) WPA-PSK2
WPA-PSK2 user AES and TKIP for Same the encryption, the others are same the
WPA-PSK.
(G) WPA2
WPA2 add uses AES and TKIP for encryption, the others are same the WPA.
(H) WPA-PSK/WPA-PSK2
Another encryption options for WPA-PSK-TKIP and WPA-PSK2-AES, the others are same
the WPA-PSK.
(I)
WPA/WPA2
Another encryption options for WPA-TKIP and WPA2-AES, the others are same the
WPA.
1. 802.1X
You can enable or disable 802.X function.
2. Encryption
Select the appropriate category. Once you set up that type of encryption, second LAN
PC must enter the same encryption type as the first one.
By pressing “WPS Setup”, you can configure and enable the easy setup feature WPS
(Wi-Fi Protection Setup) for your wireless network.