AirLive OD-600HD - Manual (Page 29)

5. Administrating the Device
AirLive OD-600HD User’s Manual 25
traversal when your device is located on an intranet (LAN) and you wish to make it
available from the other (WAN) side of a NAT router. With NAT traversal properly configured,
all HTTP traffic to an external HTTP port in the NAT router will be forwarded to the device.
UPnP:
To enable or disable the UPnP service here.
Friendly Name:
Shows the friendly name of this device here.
UPnP NAT Traversal
When enabled, the device will attempt to configure port mapping in a NAT router on your
network, using UPnP™. Note that UPnP™ must be enabled in the NAT router first.
Port Range:
The port range will open in NAT router.
External IP address:
Show the IP address and port for WAN access through Internet. If NAT traversal is
configured successfully, user can use this IP address and port to access this device. The
external IP address is not shown in case NAT traversal function is failed.
IP Filter
You can enter different user’s IP address which are allowing enter or denying by the device.