AirLive OD-600HD - Manual (Page 39)

5. Administrating the Device
AirLive OD-600HD User’s Manual 35
binary file and store it into your PC. Then follow the steps as bellows carefully:
1. Close all other application programs which are not necessary for firmware update.
2. Make sure that only you access this device while firmware updating.
3. Disable Motion Detection function.
4. Click “Browse” button. Select the Firmware binary file. ( Note that it must make sure that
the Firmware only applies to this device, once update, it will be burned into FLASH ROM of
system.
)
5. Once the firmware file was selected, click “Firmware Upgrade” button.
6. The upgrade progress information will be displayed. Once the uploading process
completed, the device will reboot the system automatically.
7. Please wait for timer countdown, and then you can use IPWizard II to search the device
again.
Warning!!!
The download firmware procedure can not be interrupted. If the power and/or
network connection are broken during the download procedure, it might possibly
cause serious damage to the device.
Strongly suggest that DO NOT upgrade firmware via Wireless LAN due to high error
rate possibly and don't allow any other clients to access this unit during updating
procedure.
Be aware that you should not turn off the power during updating the firmware and
wait for finish message.
Furthermore, the firmware upgrade procedure always is risk and do not try to
upgrade new firmware if it’s not necessary.
System Restart:
The device is restarted without changing any of the network settings. It means the IP
address of the device will not change after firmware upgrade.
5.1.4 Video : Configure profile
This device provides 2 modes of video profile. The first one is Mega-pixel mode which
supports video resolution up to Mega-pixel. However the maximum frame rate of this mode
is up to 15fps only. The second one is VGA mode which supports video resolution up to
VGA but frame rate can be up to 30fps. User only can select either Mega-pixel or VGA