AirLive WH-5400CPE-ESD - Manual (Page 14)

14
The following page is operation mode setting. Default operation mode is Access
Point, this connects your wireless PCs and devices to a wired network. In most
cases, no change is necessary. You can switch operation mode to Wireless
Client or Repeater mode depends on your application. Wireless Client mode can
allow AP act as a client within its range. Your Ethernet devices behind the AP
can connect to remote AP. Repeater mode is able to talk with one remote
access point within its range and retransmit its signal. Choose repeater mode if
you want to extend the range of your original AP.
Note: due to the built-in internal directional patch antenna, repeater mode and
WDS option do not apply in WH-5400CPE.