AirLive WMU-6000FS - Manual (Page 22)

Step 3: Type the “ipconfig” and press the “Enter”. Then the following message
should be found. Check the IP address, Subnet Mask, and Default Gateway
addresses are same as previous setting. If same, you are successful to set up
the network configuration.
2.2.3 Wireless Connection
Follow the steps below to connect to the AirLive WMU-6000FS in a wireless
environment. We assume that there is at least one WLAN card installed on
your computer, and AP Storage is powered on
Step 1: Enabling the WLAN card first, and check the Wireless Network
Connection properties from My Network Places.
Step 2: Select the Wireless Networks icon after entering the “Wireless
Network Connection Properties”. You will find the WMU_6000FS in the
Available networks, then select the WMU_6000FS, and click Configure to
connect.
AirLive WMU-6000FS User’s Manual 22