Aladdin Light Lift ALL700RM-CM - Manual (Page 17)

STEP 34
Adjust canopy and telescopic conduit assembly so contact plates meet before the canopy touches the ceiling.
See Diagram R.
Never allow the chandelier canopy to make contact with the ceiling before the contact plates meet. This
could interfere with the automatic shutoff system and could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage.
STEP 35
Loosen bottom screw collar ring to allow easy wire access. See Diagram R.
STEP 36
Run chandelier wires through screw collar or threaded stem and pull through fixture coupler holes. See
Diagram R.
STEP 37
Wire nut chandelier hot wire to black bottom contact plate wire, neutral to white, and ground to green.
If the chandelier has two hot wires, wire extra hot to red wire. See Diagram R. Bare ground wire from
chandelier can not touch underside of bottom contact plate. A direct short will occur.
Diagram R
Wire Nut Chandelier
Wires to Bottom
Contact Plate Wires
Bottom Screw
Collar Ring
Pull Chandelier
Wires Through
Screw Collar Loop/
Threaded Stem and
Fixture Coupler
Bottom Contact
Plate Must Meet
Top Contact Plate
Before Canopy
Touches Ceiling