Aladdin Light Lift ALL200RM-CM(Two Circuit Fixtures Only) - Manual (Page 2)

Read the following guidelines prior to installing the ALL200RM:
I. The ALL200RM must be installed by a licensed, bonded, and insured electrician.
II. The ALL200RM must be installed in an accessible location.
III. Thoroughly read, understand, and follow each step and safety warning in the ALL200RM installation
instructions and orange safety precautions supplement.
IV. Motor pulley, directional pulley(s), and chandelier pulley must be installed on the same plane. Do not
install the ALL200RM with lateral cable direction changes.
V. During installation of the ALL200RM, take one step at a time and check off each step upon completion.
VI. Call Aladdin Light Lift (877) 287-4601 if assistance is needed for installation and/or operation of
the ALL200RM. Refer to the Keyswitch Controller Guide or SmartLift Controller Guide for operation
instructions.
VII. Ignoring any safety warnings and/or symbols not only voids the warranty, but may cause death, personal
injury, and/or property damage.
VIII. The wattage of the chandelier can not exceed the wattage capacity of the ALL200RM.
IX. Give all Aladdin paperwork to property owner and/or anyone that will be using the ALL200RM.
ALL200RM Parts Bag List
A. 5/16” x 2” Lag Bolts (QTY 4)
B. 5/16” x 1¼” Fender Washers (QTY 4)
C. Screw Collar Ring (QTY 1)
D. Thread Lock (QTY 1)
E. 3/32” Allen Wrench (QTY 1)