Allen&Heath Xone S6 - Manual (Page 33)

XONE:S6 User Guide 33
JP2 JP1
MASTER PCB
Master Option Jumpers
Plug on jumpers set the options required. Plug across the two pins to
set. Plug on to just one pin to remove. This keeps the jumper
available to be re-used later in the future if needed.
Master output level The output level with MASTER control at
maximum position and VU meters reading ‘0’ is +4dBu with JP1 and
JP2 fitted. This is the factory default setting. To change this to 0dBu
remove JP1 and JP2. Access these jumpers from below the console.
JP2
LEVEL
JP1
+4dBu
JP2 JP1
0dBu