Allen & heath 21 xone:3d user guide – Allen&Heath Xone 3D User Manual
Page 21
Allen & Heath
21
XONE:3D User Guide
OUT
IN
FX2 SEND
WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE
REPLACE FUSE WITH SAME TYPE AND RATING.
UN DES MEMES CARACTERISTIQUES.
ATTENTION: REMPLACER LE FUSIBLE AVEC
DO NOT EXPOSE APPARATUS TO RAIN OR MOISTURE.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
WARNING: THIS APPARATUS MUST BE EARTHED.
CAU TI ON
100 - 240V~
47-63Hz ~ 30W MAX
MADE IN THE UK BY ALLEN & HEATH LIMITED
FUSE
T500mAL 250V 20mm
MIX OUT
LEFT
RIGHT
I
0
ON
OFF
SERIAL No:
AC MAINS IN ~
TO PC
USB
GAME/MIDI
FOOT
SWITCH
FX RETURNS
MIDI
LINE
L
R
PHONO
L
R
LINE
L
R
PHONO
L
R
LINE
L
R
PHONO
L
R
LINE
L
R
LINE
L
R
FX2
L
R
FX1
L
R
INPUT 1
INPUT 2
INPUT 3
INPUT 4
CH1
SOUNDCARD OUTPUTS
R
L
FX1 SEND
R
L
MONITOR
R
L
SPDIF
OUT
IN
L
CH2
R
CH3
L
CH4
R
CH5
L
CH6
R
IN
OUT
DIGITAL AUDIO
OPTICAL
A
B
REAR CONNECTORS
6
9
8
7
10
FX1-2 Send Output
RCA phono. Depending on the
application of the FX mix, these stereo
line level outputs can be used to feed
samplers and other effects units, an
additional monitor, zone or recorder.
8
Soundcard Outputs
RCA phono.
Outputs from the internal soundcard.
These are always available irrespective of
the source selection on the stereo
channels. These outputs could be fed to
an additional mixer or processor before
being brought back into the mix.
Depending on the soundcard operating
mode, signals are available on sockets 1-6
or 1-4.
9
SPDIF DIGITAL INPUTS
AND OUTPUTS
SPDIF is a popular digital audio interfacing
standard for connecting two channel
(stereo) audio using a single coax (RCA
phono socket) or optical fibre (Toslink
socket) cable.
For reliable connection use a 75 ohm coax
cable intended for this function. Avoid
the use of cheap audio cables. Use
purpose made optical fibre cables for
connection using the Toslink port. Make
sure the blanking plugs provided are fitted
to any unused Toslink sockets.
The SPDIF inputs and outputs are available
only when your computer is connected via
the USB port. The computer provides the
clocks needed for the soundcard to
function.
Sample rates of 44.1 and 48kHz are
supported with the ability to interface
with any digital source up to 192kHz.
Use the Xone:3D Configuration Utility
software to select which signals are
routed to the SPDIF connectors.
Mix Output
Balanced XLR. This is the main
output that feeds the house PA
system. Plug into the house
processor/amplifier system using
balanced cables. Use balanced
cables and equipment.
6
Monitor Output
RCA phono. Provides a line level
stereo feed to the DJ local monitor
amplifier system. It is not affected
by the master fader or cue system.
Can also be used as an alternative
zone or record output.
7
10