Allen&Heath DANTE - Manual (Page 5)

iLive M-DANTE Option Instructions 5 AP8340 issue 4
Release 1 – Firmware version 3.4.15
Release 2 – Firmware version 3.6.4
Note If you are upgrading from version 3.4.15 your module will change
into Redundant Mode. This can be changed back to Switched mode
using Dante Controller if you wish.
Note The Control Port does not output audio as it did in Release 1.
Note There is a known issue in version 3.6.4 that the Control Network
port will not work unless a Dante device is plugged into the Primary port.
If you wish to configure your Dante card without connecting it to another
Dante device plug your computer into the Primary port instead.
Control Network
Primary Secondary
Lnk/Act GigE
Lnk/Act
ALLEN
Lnk/Act
& HEATH
Control Network
Did not support bridging of the console
network over Dante, for example to run iLive
Editor and Dante Controller on the same
computer. Although intended for control
only, audio was available at this port. Secondary Port
Did not support dual redundant link
connection. The Primary and Secondary
ports together with the Control port could
provide a three port Dante switch for
connecting up to three devices.
Control Network
Primary Secondary
Lnk/Act GigE
Lnk/Act
ALLEN
Lnk/Act
& HEATH
Control Network Port
Now supports bridging of the console
network over Dante, for example to run
iLive Editor and Dante Controller on the
same computer. Audio is not available at
this port. Secondary Port
Now supports dual redundant link connection.
The card provides a choice of two modes:
Redundant Mode (default)
Switched Mode (Two port switch)
To Dante device
Controller Controller Controller