Allen&Heath GS-R24M - Manual (Page 16)

Allen & Heath 16 GS_R24 User Guide
STEREO INPUT CHANNEL
REAR PANEL CONNECTIONS
FRONT PANEL CONTROLS
ST1 (& ST3) Phono sockets
Standard RCA phono sockets for unbalanced stereo inputs.
Nominal level = 0dBu
ST1 Level
The input level control varies the level of the signal from off (fully attenuated)
to +10dB of gain at the maximum position.
ST2 (& ST4) Jack sockets
Standard 1/4” (6.25mm) Jack socket for balanced or unbalanced line level
signals. Wired Tip=Hot(+), Ring=cold (-), Sleeve=Chassis.
The left channel input is connected to the break contacts of the right channel
input socket so a mono source can feed both left & right channels if required.
Nominal level = 0dBu
10
-30
-20
-5
0
5
-10
ST1
LEV
O O
To LR
To CH
10
-30
-20
-5
0
5
-10
O O
ST2
LEV
SIP SAFE
ST1 input routing switch
ST1 (& ST3) can be routed directly to the main L-R mix bus (switch up) or to
the corresponding stereo channel section where the signals will sum with the
ST2 (& ST3) inputs from the jack sockets.
ST Channel SiP Safe switch
The Solo in Place Safe switch isolates the stereo channel from the muting
function of the Solo in Place system. Designed so that if effects are returned
to one or both stereo channels, they can be safe from muting by the SiP sys-
tem thereby allowing any soloed channels to be heard with effects intact.
ST2 Level
The input level control varies the level of the signal from off (fully attenuated)
to +10dB of gain at the maximum position.
ST1
IN
R
L
ST2
L/M
R
IN