Allen&Heath XONE DB2 - Manual (Page 27)

Allen & Heath XONE:DB2 User Guide 27
AP8640_2
USB SOUNDCARD ROUTING
CHANNEL SOURCES
Each of the USB audio sends can source from various points within
the XONE:DB2 Input Channels. From the diagram, the three
options are Analogue In, Digital In and Channel PFL.
ANALOGUE IN - The analogue sources are arranged as follows:
CHANNELS 1 AND 4 - LINE INPUT ONLY
CHANNELS 2 AND 3 - SWITCHABLE LINE /PHONO
DIGITAL IN - The source connected to digital input 1 or 2.
CHANNEL POST FADER - The signal from the channel that is sent
to the mix.
MIXER SOURCES
MIX OUTPUT - Routes the chosen send to the Mix Output. For more information on Mix Output
source options, please refer to Page 22.
PHONES OUTPUT - Routes the chosen send to the Phones Output. For more information on
Phones Output source options, please refer to Page 22.
MAPPING A SOUNDCARD INPUT SEND
For details on selecting Soundcard Input Send sources please see “USB Routing” on Page 24.
The USB audio sends can also source from any of the
mixers outputs. From the diagram, the four options
are the Booth Output, Record Output, Mix Output
and Headphone (CUE bus) Output.
BOOTH OUTPUT - Routes the chosen send to the
Booth Output. For more information on Booth
Output source options, please refer to Page 21.
RECORD OUTPUT - Routes the chosen send to
the Record Output. For more information on
Record Output source options, please refer to Page
23.
R
I
A
A
R
I
A
A
PH/LN
ADC
A
N
A
D
IG
I
N
P
U
T
C
H
A
N
N
E
L
P
O
S
T
F
A
D
E
R
CHANNEL SOURCES
MIXER SOURCES
PHONES MIX RECORD BOOTH
SOFT TRIM SOFT TRIM SOFT TRIM SOFT TRIM
LEVEL LEVEL LEVEL
MICROPHONE INPUT
Each USB send can also be mapped to the pre and post level microphone input.