Altman Lighting ODEC Series - Manual

Altman Stage Lighting Company, Inc. 57 Alexander Street, Yonkers, NY 10701
914-476-7987 212-569-7777 FAX: 914-963-7304 www.altmanltg.com
ODEC SERIES SAFETY INSTRUCTIONS AND OPERATING PROCEDURE - SAVE THESE INSTRUCTIONS
CAUTION: Read and understand these entire instructions before proceeding.
CAUTION: Always wear safety goggles that provide adequate shatter and UV protection and leather gloves or the like when servicing
or adjusting this fixture.
CAUTION: Disconnect fixture from electrical supply before initial lamp installation, relamping, or servicing for any reason. Certain
adjustments require that the lamp be energized, as indicated on opposite page). Use extreme caution when making those adjustments.
Do not look directly at lighted lamp. Do not touch lighted lamp.
CAUTION: Risk of electrical shock; this unit must be grounded when operating.
CAUTION: Do not use this fixture on a dimmable circuit.
CAUTION: Do not expose internal components to rain or other adverse weather conditions.
CAUTION: Do not operate in temperatures below -10ºF (-23ºC) or above 120ºF (49ºC).
CAUTION: This fixture is a source of intense heat and is not intended for residential use. Risk of fire or injury, avoid contact by
persons or materials. If fixture is hot, allow it to cool before relamping.
CAUTION: Do not touch glass portion of lamp with your hands. Agents such as sodium, grease, or oil from your fingers may be
transferred to the glass wall. These contaminants can cause lamp to rupture or can greatly reduce the performance and life of the lamp.
If accidentally soiled, immediately clean the lamp with a soft, clean, lint-free cloth soaked in methylated spirits (denatured alcohol), and
then wipe with a dry, soft, clean, lint-free cloth.
CAUTION: Never allow materials to come in contact with hot lamp. Protect lamp from abrasions and scratches.
CAUTION: Do not operate fixture with damaged cord, wires, connectors or components.
CAUTION: Keep access door closed and latched when except when servicing or adjusting this fixture. These lamps reach very high
temperatures. Under certain circumstances, internal or external influences may cause lamp to rupture.
CAUTION: Keep all pan and tilt bolts tight. Make sure safety cable is attached to unit at all times.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT  ALTMAN STAGE LIGHTING CO., INC., 2004. ALL RIGHTS RESERVED PAGE 1
SOCKET
PLATE
SCREWS (A)
SOCKET (B)
COLLAR STOP (C)
(NOT VISIBLE)
SAFETY
CABLE
LOOP
LENS CARRIER
SCREWS (E)
SHUTTER ADJUSTMENT
STUD (F) (ONE OF FOUR)
REMOVABLE
TOP RETAINING
CLIP (M)
NON-REMOVABLE
RETAINING CLIPS (N)
SIDE PIVOT
BOLT (P) (ONE
EACH SIDE)
SIDE LOCKING
BOLT (Q) (ONE
EACH SIDE)
LAMP
ADJUSTMENT
KNOB (D)
REAR LENS
CARRIER (H)
DONUT (K)
COLOR
FRAME (L)
PATTERN HOLDER
RETAINING SCREWS (G)
PATTERN HOLDER
INDEX TAB (J)
PATTERN
RETAINING
SCREW (I)
PATTERN HOLDER
INDEX TAB (J)
FRONT LENS
CARRIER
CENTER PIVOT
BOLT (O)
ACCESS DOOR
LATCH (ONE
OF FOUR)
ON-OFF SWITCH (NOT
SHOWN - LOCATED BELOW
ELECTRONICS ASSEMBLY)
ELECTRONICS
ASSEMBLY (NO
USER SERVICE-
ABLE PARTS
INSIDE)