Anchor CENTURY 100 WIDE, ONE-PIECE - Manual (Page 7)

7
LACING
With tent sections on ground, overlap rings (or plates) at
center pole holes with grommet side on top. Starting at
end opposite long loop, lace between center pole holes
fi rst. Push fi rst loop up through corresponding grommet.
Continue lacing process. Attach ridge snap to ring as
you come to them. Tie off last long loop.
Cover lacing by joining protective fl aps using Maxi Grip
tool.
LACE
Secure fl ap with buckles at top and bottom.
Then lace from center pole to eave on both sides of tent.
Tie off last long loop. Align plates and attach hook on
inside of tent as shown.
Attach two guy webs through both plates.
Lace all sections of tent.
TENT LAYOUT
Drive stakes at points located. Each 2’ stake bar requires (3) 42” double head stakes. Each 4’ stake bar requires (6) 42”
double head stakes.
Spread drop cloths and unroll tent.
Caution: Any objects with sharp projections which must remain on site under the tent should be padded and taped.
3
2