Atop Technology SE5002 Installation Guide - Manual (Page 3)

Quick Start Guide Version 1.3
ABLELink
® Ethernet Serial Server
SE5002
Copyright © 2006 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
2
Fig. 1 LAN LED
Message Description
Off Ethernet Disconnected
Blinking with Green Data transmitting on Ethernet at 100Mbps
Blinking with Orange Data transmitting on Ethernet at 10Mbps
Table 1. LAN LED Message
Fig. 1.
Fig. 2 COM Port LED
Message Description
Off
No data transmitting on COM port
Com 1(2)TX Blinking Data transmitting on COM port
Com 1(2)RX Blinking Data Receiving on COM port
Table 2. COM Port LED Message
Fig. 2.
Fig. 3RUN LED
Message Description
On
Jumper JP1 Pin1 and Pin2 are shorted to disable AP firmware
Blinking (rate: 0.5 Sec) AP firmware running normally
Table 3. RUN LED Message
Fig. 3.
Installation Procedures:
Step 1: Connect SE5002 to power source
Step 2: Connect SE5002 to the Ethernet network. Use a standard straight-through Ethernet cable when
connect to a hub/switch, or connect to a PC‘s Ethernet port via a cross-over Ethernet cable. However,
Always make sure your PC is on the same network sub-net as SE5002.
Step 3: Connect SE5002’s serial port to a serial device.
Step 4: Mount SE5002 to a wall/panel with the screws included or Din-Rail rack (Require optional item model:
Din-Rail-Kit).
3 Software Setup
Default Network Setting: Default User Name/Password:
IP:
10.0.50.100 User Name: admin
Gateway: 10.0.0.254 Password: null (leave it blank)
Subnet: 255.255.0.0
Auto IP (Dynamic IP):
A DHCP server can automatically assigns the IP address and all the network settings. SE5002 supports the
DHCP client function. By default, the DHCP client function on SE5002 is disabled; you may activate the
DHCP client functions by executing SerialManager (Fig. 4)
Fig. 4. SerialManager utility Dialog Window
Assign a Static IP address by: