Autoquip GATES VERTICAL ACTING - Manual (Page 28)

28
INSTALLATION INSTRUCTIONS
WARNING !
Never run the unit with the gates or doors open! The gates must
not open when the lift is in operation or when the platform is not
present. Should this condition exist, the interlock is not
functioning properly due to incorrect installation or damage.
This condition must be corrected immediately. Failure to correct
this condition may result in serious injury or death.
HG-1 WIRING INFORMATION
• The contact block is wired in series between the terminals specified on the
electrical schematic.
DANGER !
Qualified personnel only!! Only qualified service personnel
should perform procedures labeled as “dangerous”!