Autoquip SERIES 35 ROVER MOBILE - Manual (Page 20)

20
PROCEDURE FOR A LIFT ORDERED WITH AN ACCORDION SKIRT
1.
Position the platform in the raised position. Install the maintenance locks (see
“Lift Blocking Instructions” section). Position the accordion with the weight rod
pocket at the bottom and the mounting collar at the top. The breathable material
when provided must be positioned at the top of the skirt with the mounting collar.
2.
Slip the skirt over the end of the platform. Turn the skirt as required to slide over
the other end of the platform and leg assembly. The skirt should be in position
under the platform while enveloping the base assembly.
3.
See the drawing below and select the correct mounting configuration (Figure 1,
2, or 3 from the drawing).
Figure #1: Mounting an Accordion Skirt Onto the Platform Side
Raise one side of the skirt along with a skirt -mounting bar (1/8” x 1”) to (1) side
of the platform. When possible, center the skirt-mounting collar and skirt-
mounting bar (1/8” x 1”) on the platform side. Align the pre-drilled holes in the
side of the platform with the skirt-mounting bar holes and punch holes in the skirt-
mounting collar. Push a nylon drive rivet through each hole in the skirt-mounting
bar. Hammer the aluminum pin into the rivet until flush with the rivet head.
Repeat mounting process for the remaining sides of the accordion skirt.
Figure #2: Mounting an Accordion Skirt Underneath the Platform
Raise one side of the skirt along with a skirt-mounting bar (1/8" x 1") to the
underside of the platform skirt support bar. When possible, center the skirt
mounting collar and the skirt-mounting bar (1/8” x 1”) on the platform support bar.
Align the pre-drilled holes in the skirt support bar (picture frame) with the skirt -
mounting bar holes and punch holes in the skirt-mounting collar. Push a nylon
drive rivet through each hole in the skirt-mounting bar. Hammer the aluminum
pin into the rivet until flush with the rivet head. Repeat mounting process for the
remaining sides of the accordion skirt.
Figure #3: Mounting an Accordion Skirt Onto the Bevel Toe Guard
Raise one side of the skirt along with a skirt-mounting bar (1/8” x 1”) to the side
of the bevel toe guard. When possible, center the skirt mounting collar and the
skirt-mounting bar (1/8” x1”) on the platform bevel toe guard. Align the pre-drilled
holes in the bevel toe guard with the skirt-mounting bar holes and punch holes in
the skirt-mounting collar. Push a nylon drive rivet through each hole in the skirt-
mounting bar. Hammer the aluminum pin into the rivet until flush with the rivet
head. Repeat mounting process for the remaining sides of the accordion skirt.
4. Install weight rods into the weight rod pockets at the bottom of the accordion
skirt. Install the spring tempered wire rods into the pocket of black convolutions.
INSTALLATION INSTRUCTIONS