Autoquip SERIES 35 ROVER MOBILE - Manual (Page 40)

40
PROBLEM POSSIBLE CAUSE AND SOLUTION
Lift seems bouncy during
operation.
 Battery connections may be loose. Check
connections.
 Lower the lift to collapsed position and continue to
hold “DOWN” button an additional 10-30 seconds to
bleed air from the cylinder. Do not confuse spongy
or jerky operation with small surges that may occur
when operating on rough or uneven floors
 Check for oil starvation.
Motor labors or heats
excessively.
 The voltage may be low. Check at the motor
terminals while the pump is running loaded, not at
the line source or while the pump is idling.
Inadequate wiring can starve the motor even when
the source voltage is ample.
 Most of Autoquip’s standard motors are rated for
intermittent duty (two minute run times with two
minute rests). If a single-phase motor is being run
more than 15 – 20 motor starts per hour, or a 3-
phase motor more than 200 starts per hour, the
problem may be motor over-heating.
 Running against relief pressure unnecessarily due to
over loaded lift or hitting physical stops.
 Failure to observe wiring diagram on nameplate for
proper voltage connections.

The pump may be binding from oil starvation, which
develops high internal heat. Check for low oil level
or closed breather holes in the reservoir fill plug.
The pump can be irreparably damaged by oil
starvation and may have to be replaced.
TROUBLESHOOTING ANALYSIS