Installation instructions, Caution, Danger – Autoquip SPIRALIFT SCISSORS LIFT User Manual
Page 16
16
CAUTION!
When moving the lift, do not attempt to pick it up by the platform; it is
hinged and could be damaged. Pick up the lift from under the base frame
ONLY using lifting eyes or a strap sling.
4.
Remove the shipping straps (the lift is shipped in a slightly raised position for
checking rotation).
5.
Check wiring connections to the motor for proper rotation of the spiral mechanism.
6.
Make temporary electrical connections. Raise and lower the lift to make
positioning adjustments and align the platform in the pit with a proper clearance of
3/4” minimum around the edges from the platform to the pit angle.
DANGER
!
Do not work under lift without Maintenance Device! To avoid personal
injury, NEVER go under the lift platform until the load is removed and the
scissors mechanism is securely blocked in the open position. See "Lift
Blocking Instructions" section.
7.
The base frame of the lift has pre-drilled holes for lagging the lift securely to the
floor. Mark hoes, drill, and install with anchors. Lifts with oversize platforms have
minimum pull out requirements of 2,000 lbs. for each anchor.
8.
Make the permanent electrical connections and operate the lift through a few
cycles.
9.
Apply all warning labels in the correct location. See “Label Identification” section.
10. Clean up any debris from the area. A clean installation makes a good impression
and creates a much safer environment!
INSTALLATION INSTRUCTIONS